Replacement Surge Module for 30A WiFi Units (GEN II + Powercenter)
*** This replacement surge protection module is only for the PWD30EPOW, PWD30EPOHW, PWD30W, WPC30 units. It is designed for use only with the 30 Amp 'generation 2' WiFi and Watchdog Powercenter units. ***
THIS IS NOT COMPATIBLE WITH GEN 1 UNITS!
Simple installation! The only tool required is a Phillips screw driver.
INSTRUCTIONS
UNPLUG THE UNIT - make sure unit is fully disconnected from any power prior to installation.
Unscrew 6 Phillips screws on the back of the unit (*7 screws for the EPO versions).
Unscrew the top cable gland nut and move it up the cord.
Carefully, separate the two halves of the body
The surge module slides in/out of the slot. Unclip the one red/black wire, and loosen the screws holding the fork wire connectors to the wire leads.
Disconnect the old surge module from the unit.
Connect the new surge protection module and wires. "G" is ground and green color, "N" is neutral and white color, "L
Replace all the screws and re-tighten the cable gland nuts.
Part Number: RSM30W
CAUTION!
Make sure unit is unplugged before installation!
*** This replacement surge protection module is only for the PWD30EPOW, PWD30EPOHW, PWD30W, WPC30 units. It is designed for use only with the 30 Amp 'generation 2' WiFi and Watchdog Powercenter units. ***
THIS IS NOT COMPATIBLE WITH GEN 1 UNITS!
Simple installation! The only tool required is a Phillips screw driver.
INSTRUCTIONS
UNPLUG THE UNIT - make sure unit is fully disconnected from any power prior to installation.
Unscrew 6 Phillips screws on the back of the unit (*7 screws for the EPO versions).
Unscrew the top cable gland nut and move it up the cord.
Carefully, separate the two halves of the body
The surge module slides in/out of the slot. Unclip the one red/black wire, and loosen the screws holding the fork wire connectors to the wire leads.
Disconnect the old surge module from the unit.
Connect the new surge protection module and wires. "G" is ground and green color, "N" is neutral and white color, "L
Replace all the screws and re-tighten the cable gland nuts.
Part Number: RSM30W
CAUTION!
Make sure unit is unplugged before installation!
*** This replacement surge protection module is only for the PWD30EPOW, PWD30EPOHW, PWD30W, WPC30 units. It is designed for use only with the 30 Amp 'generation 2' WiFi and Watchdog Powercenter units. ***
THIS IS NOT COMPATIBLE WITH GEN 1 UNITS!
Simple installation! The only tool required is a Phillips screw driver.
INSTRUCTIONS
UNPLUG THE UNIT - make sure unit is fully disconnected from any power prior to installation.
Unscrew 6 Phillips screws on the back of the unit (*7 screws for the EPO versions).
Unscrew the top cable gland nut and move it up the cord.
Carefully, separate the two halves of the body
The surge module slides in/out of the slot. Unclip the one red/black wire, and loosen the screws holding the fork wire connectors to the wire leads.
Disconnect the old surge module from the unit.
Connect the new surge protection module and wires. "G" is ground and green color, "N" is neutral and white color, "L
Replace all the screws and re-tighten the cable gland nuts.
Part Number: RSM30W
CAUTION!
Make sure unit is unplugged before installation!